Indigresso Wiki

Open Source Stuff for DASH7

User Tools

Site Tools


dash7_mode_2:registry_guide

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
dash7_mode_2:registry_guide [2012/04/19 19:07]
jpnorair [Scan & Beacon Series (ISF 04, 05, 06)]
dash7_mode_2:registry_guide [2012/04/19 19:09] (current)
jpnorair [Scan & Beacon Series (ISF 04, 05, 06)]
Line 297: Line 297:
 In this data element structure, the "​window interval"​ described earlier in the section is determined by the value of "Next Scan." ​ The "Scan Timeout"​ value determines the duration of time where the radio is actively listening for some data on the channel (i.e. RX mode active, searching for sync word). ​ If the Scan Type value is set, there is also a stipulation that carrier sense detection must be valid.  ​ In this data element structure, the "​window interval"​ described earlier in the section is determined by the value of "Next Scan." ​ The "Scan Timeout"​ value determines the duration of time where the radio is actively listening for some data on the channel (i.e. RX mode active, searching for sync word). ​ If the Scan Type value is set, there is also a stipulation that carrier sense detection must be valid.  ​
  
-So, for these "​background scans" (see [[dash7_mode_2:​dll|DLL),​ the active scanning will terminate under __any__ of the conditions below:+So, for these "​background scans" (see [[dash7_mode_2:​dll|DLL]]), the active scanning will terminate under __any__ of the conditions below:
    - Carrier Sense is not detected within threshold set in the selected channel'​s Channel Configuration Element (ISF 02)    - Carrier Sense is not detected within threshold set in the selected channel'​s Channel Configuration Element (ISF 02)
    - Scan Timeout occurs    - Scan Timeout occurs
Line 317: Line 317:
 | Channel ID         ​| ​ 1      |  0       | Transport Channel ID (see [[dash7_mode_2:​phy|PHY]]) for scan        | | Channel ID         ​| ​ 1      |  0       | Transport Channel ID (see [[dash7_mode_2:​phy|PHY]]) for scan        |
 | Command Params ​    ​| ​ 1      |  1       | Bitfield parameters that map to Data Link Layer and M2QP command request parameters | | Command Params ​    ​| ​ 1      |  1       | Bitfield parameters that map to Data Link Layer and M2QP command request parameters |
-| M2QP Call Template |  4      |  2       | Single File or File Series Call Template, padded to 4 bytes (see [[dash7_mode_2:​m2qp|M2QP) ​ |+| M2QP Call Template |  4      |  2       | Single File or File Series Call Template, padded to 4 bytes (see [[dash7_mode_2:​m2qp|M2QP]])  |
 | Next Beacon ​       |  2      |  6       | Integer number of ticks (1/1024s) between start of present beacon and start of next beacon ​ |  | Next Beacon ​       |  2      |  6       | Integer number of ticks (1/1024s) between start of present beacon and start of next beacon ​ | 
  
dash7_mode_2/registry_guide.txt ยท Last modified: 2012/04/19 19:09 by jpnorair